Hello,
Does the feather connect to the LTE link monitor app?
I have tried it to connect, but the serial port of the LTE link monitor says No devices available. Similar when trying to connect to nRF programmer.
Unsupported device. The detected device could not be recognized as neither JLink device nor Nordic USB device.
I guess this is due to the serial to the USB converter that is on-board is different than that recognized by the nRF Connect.
Any suggestions?
Thanks
raj have you checked this out? https://docs.jaredwolff.com/nrf9160-nrf-connect-desktop.html#using-with-lte-link-monitor
jaredwolff thank you. I think I missed this section. Will try it out.
raj K! Keep me posted if you need anything else. 
Thanks, the LTE link monitor now works after following the outline however, the programmer still does not recognize the device.
Link monitor OK as shown.
https://drive.google.com/file/d/1vv1UJ2-36Giw2BRhksT-K2RylBFiRC3l/view?usp=sharing
Programmer
https://drive.google.com/file/d/1d7PX9I7EnN4Gaiv1osJI3a7mYDGedqeS/view?usp=sharing
https://drive.google.com/file/d/1ZWcski42I7mONYXhAuGpdJBkFYsl-Qia/view?usp=sharing
raj check out the documentation on external programming here:
https://docs.jaredwolff.com/nrf9160-programming-and-debugging.html#requirements-for-external-programming-and-debugging
Otherwise you can load new firmware using newtmgr here:
https://docs.jaredwolff.com/nrf9160-programming-and-debugging.html#booloader-use
jaredwolff
Atm newtmgr is my goto for flashing the device, so no problem there.
But was just trying to set everything up so that it also works with nRF apps.
Thanks
raj Gotcha. You need an external programmer to use the nRF app. Hope that makes sense!
